Showing items 781 - 800 of 112,167 results.
Maintenance & Troubleshooting
Posted:
27 May 2025 15:29
by
Hein
i have a Clark c30 P232l-0632-9862CN. every now and then it would ran rough and would stink when running. like...
Maintenance & Troubleshooting
Posted:
27 May 2025 15:24
by
SUBHASH_BHOSALE
Plz send feedback problem solve or not slove
Maintenance & Troubleshooting
Posted:
27 May 2025 15:13
by
Hein
Is there a way to test to verify faulty t-pod. If i install a new one how would i calibrate....
Maintenance & Troubleshooting
Posted:
27 May 2025 01:20
by
John_Bradley
What you are describing sounds like low battery , have you charged the battery and checked water in battery ?...
Maintenance & Troubleshooting
Posted:
26 May 2025 23:03
by
marksmith
29 ETCDriverFault
Throttle driver over-current or driver signals shorted
Disable Throttle Check ETC driver wiring for a shorted circuit
Maintenance & Troubleshooting
Posted:
26 May 2025 20:22
by
Zeiad_Yehia
Hello
I have same problem
Please help me to solve it
Maintenance & Troubleshooting
Posted:
26 May 2025 04:13
by
AKPJ
Need some help getting my orderpicker back in service. The battery is good, there is no voltage drop when its...
Maintenance & Troubleshooting
Posted:
25 May 2025 22:41
by
lifter01
Faulty throttle pot will need replacing and calibrating easy job to do and a very common fault on all Lindes
Maintenance & Troubleshooting
Posted:
25 May 2025 22:38
by
lifter01
How is the motor sealed?? Is it in a full enclosure or just the brush gear in an enclosure?? Who...
Maintenance & Troubleshooting
Posted:
25 May 2025 17:47
by
vittek
Accelerator (reference signal): broken cable or short-circuit
Maintenance & Troubleshooting
Posted:
25 May 2025 07:57
by
harry_perkins
Hey there thanks for the feed back I did pull the right side drum of and all looked good I...
Maintenance & Troubleshooting
Posted:
25 May 2025 05:32
by
Fritzthecat
46mm socket
Maintenance & Troubleshooting
Posted:
25 May 2025 02:24
by
Darkestskydiver
have you pulled the axles and removed the drums to do an inspection on the components, it sounds like the...
Maintenance & Troubleshooting
Posted:
24 May 2025 23:35
by
Sf33
Seeking assistance with big joe walk begins stacker. Had a a bad ac steering motor and steering poteniiometer. Replaced both....
Maintenance & Troubleshooting
Posted:
24 May 2025 23:16
by
Necy
Hi,
we have an 3,5t diesel Toyota forklift (8.000h). The issue with the transmission started as the hose of the...
Maintenance & Troubleshooting
Posted:
24 May 2025 18:19
by
harry_perkins
Hey there i am currently working on a fork lift and trying to trouble shoot a problem of the left...
Maintenance & Troubleshooting
Posted:
24 May 2025 17:56
by
John_Hubbard
Hi all, I have just replaced the seals on the two lift rams (might have heard this model referred to...
Maintenance & Troubleshooting
Posted:
24 May 2025 13:18
by
Darkestskydiver
i know this is a little old but, the solenoid should only have power when the trans control unit sends...
Maintenance & Troubleshooting
Posted:
24 May 2025 12:47
by
Darkestskydiver
is this a dual fuel truck? there shouldn't be lp guage on the dash as there is no way of...
Maintenance & Troubleshooting
Posted:
24 May 2025 12:45
by
Darkestskydiver
the data connector is under the cup holder, however with the perkins engine you need to have the cat adapter...
Forkliftaction accepts no responsibility for forum content and requires forum participants to adhere to our rules of conduct. Click here for more information.
If you are having trouble using the Discussion Forums, please contact us for help.