Good morning/afternoon.
I have a Hyster S50ft F187V10079E with Mazda 2.2L LPG emission compliant engine. I replaced the cam seal and timing belt on it.
When removing the CAM angle sensor from the front housing, I must have spun it. The CAM angle sensor looks like a distributor without a rotor and cap.
I forgot to mark it (I know I should know better) and I don't remember how to set it to the cam.
There is a black mark on the washer that holds the disk that has the cut-outs.
I don't see any markings on the housing to line anything up.
Any help would be appreciated.