Good morning/afternoon.
I have a Hyster S50ft F187V10079E with Mazda 2.2L LPG emission compliant engine. I replaced the cam seal and timing belt on it.
When removing the CAM angle sensor from the front housing, I must have spun it. The CAM angle sensor looks like a distributor without a rotor and cap.
I forgot to mark it (I know I should know better) and I don't remember how to set it to the cam.
There is a black mark on the washer that holds the disk that has the cut-outs.
I don't see any markings on the housing to line anything up.
Any help would be appreciated.
This is ONLY to be used to report flooding, spam, advertising and problematic (harassing, abusive or crude) posts.