We're working on a Toyota 8FGU45 forklift with a 3.7L 4-cylinder engine. The drive shaft broke and was recently repaired. However, after the repair, the engine won't start. We're getting 12 volts to the coil-on-plug ignition system (no distributor), but there's no spark at the plugs.
We've already replaced both the camshaft and crankshaft position sensors, but we're still not getting a signal (no pulse).
Has anyone run into a similar issue or have any suggestions on what else to check?
Forkliftaction accepts no responsibility for forum content and requires forum participants to adhere to our rules of conduct. Click here for more information.
If you are having trouble using the Discussion Forums, please contact us for help.