Wont go into gear - Technical Troubleshooting discussion in Forkliftaction's forums

Doosan (& Daewoo) D110:
Wont go into gear

R1st off this truck is for disaster relief in North Carolina. Desperare situation. Reppinstalled the mast on a d110.after customer shipped to us with mast off. Now unit wont go into gear. Indicator say BA on dash in fwd or rev and N in neutral. We pulled it to move it running in gear and it started to work properly. But BA. Status still on. Ran for 5 min with no issues
Set air park brake and released it.now it failed again.and wont work by pulling it now.this

Posted 12 Sep 2018 21:04
Discussion started by vince
Illinois, United States

Vince

Post a Reply Report this post

Showing items 1 - 2 of 2 results.

Sort messages by:

That sensor will be located on the transmission likely near the filter rather than on the Differential as mentioned above. The cab can be tilted over to allow better access. When tilting cab assure the mast is tilted fully forward.

Posted 13 Sep 2018 03:24
Reply by tom_p
Alberta, Canada

Post a Reply Report this post

BA fault indicates differential oil pressure loss. Check the wiring to pressure sensor on drive axle and fluid level, wiring may have been damaged or disconnected when mast was removed.

Posted 13 Sep 2018 03:11
Reply by tom_p
Alberta, Canada

Post a Reply Report this post

Post your Reply

Forkliftaction.com accepts no responsibility for forum content and requires forum participants to adhere to the rules. Click here for more information.

Having trouble using the Discussion Forums? Contact us for help.