Well lads,
Working on an electric Hyster 1.80 48V
(Not sure if the model is right)
Anyways, the truck is putting up two codes.
Code 238 traction control fault
Code 203 brake fluid low (although it's full)
The trucks hydraulics also aren't working except for steering an it is in limp mode.
Any ideas?
It's a ZAPI controller, one board was sent away to be checked for faults but came back ok.
Could it be the controller itself?
This is ONLY to be used to report flooding, spam, advertising and problematic (harassing, abusive or crude) posts.