Figured I would post an update. I was able to get he MIL light to blink out 3 digit codes by doing the "Pedal Maneuver"

The Pedal Maneuver procedure is below if anyone else needs the information.

"Displaying Fault Codes (DFC)
from SECM Memory
To enter code display mode you must turn OFF the
ignition key. Now turn ON the key but do not start
the engine. As soon as you turn the key to the ON
position you must cycle the foot pedal by depressing
it to the floor and then fully releasing the pedal
(pedal maneuver). You must fully cycle the foot
pedal three (3) times within five (5) seconds to
enable the display codes feature of the SECM.
Simply turn the key OFF to exit display mode. The
code list will continue to repeat until the key is
turned OFF. "