I have finally identified the issue. Its the DC-SD? board. The board that is part of the drive panel but over to the side. For some reason an identical board (same part number) was used for the material handling chopper so I was able to swap them and my C0 became an E0. so now instead of being able to lift not drive I can drive not lift. I ordered a used board and should have it tomorrow. Thanks for your help.

P.S. I now have many extra parts that I bought used and did not end up needing for this lift nearly an entire drive panel with boards, contactors, diodes, etc. I have several resistor assemblies and more. Does anyone have any suggestions on where I might sell them?