No power - Technical Troubleshooting discussion in Forkliftaction's forums

Crown WAVE 50:
No power

Hello people. When I turn the key to the on position it beeps once, the light display goes through the startup process and then display goes blank and I have no operation.

Batteries are showing 24.1V even after a full charge. It's as if I have no power available.

Any thoughts or ideas?

Thank you

Beau.

Posted 25 Apr 2024 19:53
Discussion started by Beau_Block
New South Wales, Australia

Blocky

Post a Reply Report this post

Showing items 1 - 1 of 1 results.

Sort messages by:

24.1v is below the point of lift lockout. A full charge should be above 25v. Possibly one or more of the batteries are dead/dying. I would check the individual batteries to ensure they are all over 6v. If they are under 6v they should be replaced. I recommend replacing all of them rather than just one at a time.

Posted 10 May 2024 02:57
Reply by DyslexicNerd_01
Wisconsin, United States

Post a Reply Report this post

Post your Reply

Forkliftaction.com accepts no responsibility for forum content and requires forum participants to adhere to the rules. Click here for more information.

Having trouble using the Discussion Forums? Contact us for help.