1. Home
  2. Forums
  3. Technical Troubleshooting

Cat Lift Trucks (& Caterpillar) V50D:
Timing chain alignment

Looking for timing chain alignment on ct forklift with xn1p engine.
  • Posted 24 Sep 2021 09:25
  • Discussion started by Hurkrepr
  • South Dakota, United States
Post a ReplyReport this post

Post your Reply

Forkliftaction.com accepts no responsibility for forum content and requires forum participants to adhere to the rules. Click here for more information.

Having trouble using the Discussion Forums? Contact us for help.

Your Focus
Stuart Taylor
The critical role of managers in MH safety
Stuart Taylor
Read blog
From the forum discussions …
"Transmission yoke u joint... I have never seen one break. Situations that could cause this are many... Going full throttle from a standstill with a load. Pushing loads or carrying loads too heavy for the lift."
Fishmech, United States
Read & Post in our Forums
Upcoming in the editorial calendar
MATERIALS HANDLING ATTACHMENTS
Apr 2025
ARTIFICAL INTELLIGENCE
May 2025
Ask us about editorial contribution
From the forum discussions …
"...If you can find the signal wire from LHC. To the coils then you can check for volts...You may be getting the correct signal but have a valve issue"
John_Bradley, United States
Read & Post in our Forums
Toyota moves to settle US emissions case San Francisco, CA, United States

Showcased in the Virtual Expo

Machinery-onQ
Machinery-onQ.com is the one place to source and sell all your new and used machinery.
Find equipment for sale | Add a listing
VISIT
machinery-onQ.com
Machinery-onQ
Mobicon 2T
Mobicon 2T
Coraopolis, Pennsylvania, United States
New - Sale
Unicarriers FD80-2
Unicarriers FD80-2 2017
Yokohama, Japan
Used - Sale
|
Upcoming industry events …
MHEDA 2025 Annual Convention and Exhibitor Showcase
April 26-30, 2025 - Tampa, FL, United States
Intralogistics & Warehousing Expo
May 22-24, 2025 - Pune, India
Europe Green Logistics Innovation Summit 2025
June 04-05, 2025 - Frankfurt, Germany
More Events
From the forum discussions …
"Thanks mwjago... crank and cam sensor can both be changed out at the LH rear tire under neath... Again, make sure the wiring is good... I also had a unit with a broken intake manifold so check that too."
mwjago, United States
Read & Post in our Forums
Fact of the week
In 1903, the first Tour de France was held in Paris. The cycling race had been postponed and prize money boosted after it failed to draw enough competitors. Invented to lift the circulation of newspaper L'Auto, it comprised of six long stages totalling 2,428 kilometres.