1. Home
2. Forums
3. Technical Troubleshooting
4. Clark
5. TM-20 E

Clark TM-20 E:
Tilting Function inoperable

Adjusting the switch fixed my tilting issue.
Thanks Much for all your assistance Mr. Fixit!

• Posted 19 Feb 2019 05:55
• Reply by racetireman
• Michigan, United States

Post a Reply Report this post

Thank You Mr. Fixit. I will work on that repositioning and let you know how that works. In the mean time, Thanks Much for assistance.

• Posted 19 Feb 2019 00:45
• Reply by racetireman
• Michigan, United States

Post a Reply Report this post

It probably needs to be adjusted (positioned correctly) so the pump shuts off when the lever is not being used.

• Posted 16 Feb 2019 09:42
• Reply by mrfixit
• New York, United States

Post a Reply Report this post

I found a broken wire on the switch to the tilt lever. Repaired that break and tilt work again. However, now the pump constantly runs which is not how it functioned previously. Could the switch be faulty now? Or could it be positioned incorrectly now? Or does the pump need to run for a while to purge any air out of the system? Thanks for the quick reply!

• Posted 16 Feb 2019 07:33
• Reply by racetireman
• Michigan, United States

Post a Reply Report this post

Did you check the switch on the hydraulic control valve that turns on the pump when the tilt lever is used?

• Posted 15 Feb 2019 23:08
• Reply by mrfixit
• New York, United States

Post a Reply Report this post

Post your Reply

Forkliftaction.com accepts no responsibility for forum content and requires forum participants to adhere to the rules. Click here for more information.

Having trouble using the Discussion Forums? Contact us for help.