Showing items 1 - 3 of 3 results.
Q1 should come in a kit with Rec 1 if not it's recommended that Rec 1 be replaced also. Also check the snubber resistors (the big gold ones beside Q1) the resistance should be 1 ohm each.
It is usually a bad Q-1 transistor. It is available in a kit part # 828-900-101. Just going by memory on the part#. There are a few tests that can be run in the on board diagnostics and then the Q-1 can be tested with a Fluke meter. Also look at the drive motor brushes and the comm. on the motor, if they are very worn or burnt it could cause the code. It is also recommended to replace the power card if the Q-1 is shorted. Good luck.
Open detected in armature circuit- Check Fuse #5 - Visually inspect 'B' contact's tips for weld condition ( if by pass is equipped)
Forkliftaction.com accepts no responsibility for forum content and requires forum participants to adhere to the rules. Click here for more information.