When I put truck on charger it goes through cycle. Charger shuts off. When I plug battery into truck the charge indicator shows battery at 84%. I believe I need to reset discharge indicator am un sure of how too though.
Showing items 1 - 10 of 10 results.
Sounds like you found your problem. Cells are roughly $500 give or take...a few hundred, all depending on battery type and size. Wouldn't put much money in a battery older than 4 years, depending on your application.
Both 12 and 18 were at less than 1.75 volts gravity level of 12 was 1100. 18 was 1000
I did load test in process found cell 12 and 18 bad. Battery is less than 2 years old.
I would perform a load test on the battery. Do you know the age of the battery? Battery s/n?
It sounds like you have a battery problem.
I let it run down to 40% charged it. Till charger shut off it then read 100% soon as I used carriage and turned key off and back on it dropped to 70%. Could there possibly be something wrong with the regen from hydraulic motor. I believe that when the mast is lowered it recharges battery some how? Or am I incorrect in my understanding of this?
I am not sure if this applies to your truck but some of the new systems require the battery to be below a certain percentage before a recharge will reset the display. Try running the truck until the display reads below 50%. Then recharge and check it.
I put on charger again let it charge till it said it was charged. Tested voltage at battery 40.10 v./ 39.5v at access 8 panel. On lift it shows battery to be at 61%.
I did it was 37.85 volts. Though something happened when I used the carriage the voltage dropped from 84% to 61%. Going to top and back down 1 time.
I WOULD CHECK BATTERY VOLTAGE FIRST BEFORE ANYTHING ELSE
Forkliftaction accepts no responsibility for forum content and requires forum participants to adhere to our rules of conduct. Click here for more information.
If you are having trouble using the Discussion Forums, please contact us for help.