Showing items 1 - 12 of 12 results.
Check the black and white wire pins with multi meter on diode mode, it will show approx 0.53 in one direction, the other direction nothing, red and blue pin also nothing in both directions.
otherwise you need to change with new sensor bearing and observe the condition.
Hello I have the same problems motor and controller are not grounded.. how can you test those bearing encoder ? EFG320
Thanks
Also say inf:08
The only thing to rectify this is to replaced the shorted controllers, or maybe there's a shorted line contacts to the chassy having an open wire.
Error 019 is a power/voltage failure.
Like Monty/Elektrodrive says, check your earth cables.
Are you getting a code that starts with C displayed too? This may help by narrowing it down to which controller has detected the voltage drop
I know it's a long shot and may not be related but always worth a check.
I had this error twice on the same truck and I found earth leakage to lift motor. Cleared the earth and truck worked a treat. A few months later same problem and the controller itself had failed.
Open controllers and check for loose connections.
Make sure all power connections from controllers to motors are secure.
It is possible that the replacement encoder has failed, it is easy enough to damage them when fitting. They should always be pressed on and not tapped with a hammer or other heavy object.
Forklift was running for a week time. again the same error code 019 is showing. Forklift not moving and pump also not working. Checked all the three motors sensor bearings all are ok.
Please anybody can give further clue to sort out the problem.
Thank you verymuch for your clue. One of the sensor bearing is the problem. we have rectified. Once again thanks
Looks like it could be speed sensor bearing in one of the motors.
Thanks for your reply. Please find the detail
Sr.nr. FN324896
Year of manufacturing 2005
If you include serial number and age it might be easier to check.
Hello Guys anybody can explain the problem related to the error 019 in the Jungheinrich EFG320 forklift
Forkliftaction.com accepts no responsibility for forum content and requires forum participants to adhere to the rules. Click here for more information.