Unit lifts but does not travel - Maintenance & Troubleshooting discussion in Forkliftaction's forums

Discussion:
Unit lifts but does not travel

Raymond RSS40

I have a RSS40 that lifts but does not travel. When you try and use it, it flashes a code 2,3. Does anyone have any idea what to check or the cause? I have replaced the Potentiometer and Curtis box. Any help would be appreciated.

Posted 25 Apr 2019 21:21
By troy_a
joined 5 Apr'19 - 21 messages
Arkansas, United States

Post a Reply Report this post

Showing items 1 - 4 of 4 results.

Sort messages by:

I have one with same issues same code...did you ever figure it out?

Posted 5 Apr 2021 03:52
By kingkuality
joined 21 May'17 - 61 messages
Ohio, United States

Post a Reply Report this post

It should stil have a break switch and wires that go to it. Bottom of the handle. You have to remove the e clip, shaft and rubber bumper.

Posted 19 Jun 2019 09:21
Modified 19 Jun 2019 09:28 by poster
By Service_T
joined 5 May'18 - 91 messages
Kansas, United States

ServiceT

Post a Reply Report this post

This unit does not have the power break

Posted 19 Jun 2019 05:08
By troy_a
joined 5 Apr'19 - 21 messages
Arkansas, United States

Post a Reply Report this post

No travel is usually the small wiring harness that goes to the brake switch.

Posted 17 May 2019 11:27
By Service_T
joined 5 May'18 - 91 messages
Kansas, United States

ServiceT

Post a Reply Report this post

Post your Reply

Forkliftaction accepts no responsibility for forum content and requires forum participants to adhere to our rules of conduct. Click here for more information.

If you are having trouble using the Discussion Forums, please contact us for help.