Thanks for the reply... I have taken apart both of those valves and even swapped them to see if the issue would switch sides.. I swapped the wiring too. No change. As far as the solenoids getting a signal, as soon as I disconnect one, the machine gives an error code, so I'm assuming that the electrical side of things is good. I have taken apart and inspected every solenoid involved with the drive circuit and they all look good. This machine is getting extremely frustrating. With an issue this obvious, I would think I should be able to find an obvious cause. Thanks for all the effort you are putting into this.
This is ONLY to be used to report flooding, spam, advertising and problematic (harassing, abusive or crude) posts.