Report this forum post

Exhaust system was replaced on this unit also, muffler had a hole in it blowing exhaust on radiator. while counterweight was off, radiator was blown out. Unit has been run without thermostat and the same problem exsist. Fan is on correctly and at the right angle. Temp is being checked with a mech. gauge. Unit has been drove without using the the paper roll clamp or the inching pedal. It does take longer for it to overheat at an idle. Timming is set at 8 degrees @ 700 rpm's. I have just about ruled out that this problem is comming from the engine. The transmission has only been serviced. I did find some rather large metal chewed up shims in the tranny strainer. I will have to get the pressure readings on the trans. I would like to at least rule out one of the two.
  • Posted 22 Apr 2012 00:44
  • By GregM
  • joined 2 Apr'12 - 26 messages
  • Texas, United States

This is ONLY to be used to report flooding, spam, advertising and problematic (harassing, abusive or crude) posts.

Indicates mandatory field
Upcoming industry events …
November 27, 2025 - Jakarta, Indonesia
June 22-25, 2026 - Chicago, Illinois, United States
Global Industry News
edition #1256 - 13 November 2025
Automation is a key theme in the stories we have in this week’s Forkliftaction News ... Continue reading
Upcoming industry events …
November 27, 2025 - Jakarta, Indonesia
June 22-25, 2026 - Chicago, Illinois, United States

PREMIUM business

F. Uchiyama
Global exporter of used forklift and construction machinery, servicing over 80 countries.
Global Industry News
edition #1256 - 13 November 2025
Automation is a key theme in the stories we have in this week’s Forkliftaction News ... Continue reading
Movers & Shakers
Esie Cortez Esie Cortez
Vice president - IT & EP OEM parts, Big Joe Forklifts
Vice president of finance, Exotec
President - business area industrial equipment, Konecranes
Board chair, Equipment Leasing & Finance Association