Hello.
Faulty head gasket, replaced the head gasket. Head machined. Won't run on forklift gas. Will run on ether. Engine is a Continental 6 cyl. ( side valve)
Replaced Impco model J and won't start. Tested the model J and it operates if low suction is applied on its outlet with no connection on the inlet. When I connect 100 psi air on the inlet I am unable to use low suction on the outlet to get it to operate!?
Any ideas / help would be greatly appreciated. Regards
This is ONLY to be used to report flooding, spam, advertising and problematic (harassing, abusive or crude) posts.