Hi guys.
I'm struggling with a Taylor forklift.
Model GT360 (NOT GT210 as mentioned above).
Serial S-27-25792.
It doesn't go into reverse until the transmission is warmed up a bit, say 2 - 3 minutes of idling before it reacts. Forward is fine, no problem.
There was some wiring issues at the solenoids that I fixed up.
I have physically removed the solenoids and tested them on the bench, they're fine.
Any ideas before ripping out the trans?
This is ONLY to be used to report flooding, spam, advertising and problematic (harassing, abusive or crude) posts.