Working on (or being worked on by) an S20a, I believe. The stamped ID is A10D so I'm assuming that is correct. I'm trying to pull the drive axles to get to the non-existent brakes. So far I've looked at what YouTube videos are available and have followed those but am unable to pull the axle. I've used the two 7/16 14 drive holes to push the axle hub and it has moved apart from the wheel rim but won't come free. It almost acts like there might be a retainer ring on the gear end since it seems to have a bit of spring action sucking it back in a bit. I don't have a diagram or manual to go by at this point so I'm needing some experienced voices to let me know if I just need a bigger hammer. I've already stripped out 4 bolts and re-tapped the holes. Thanks.