i think CAN is ok, because when i disconnect the controller from dash, it gives error 346, also when i apply only power to the dash it gives that errorso i think CAN is fine...but maybe it's only recieving data,not sending,or other way around....

contactors are fine,wiring is fine,diodes are fine too...

i even tried to disconnect the pump so the traction would work on it's own,but it doesn't, work,same with pump...

i noticed the seat switch on the dash is red, like it's not active, but in the pump controller it says it's closed, but in the traction it says open...maybe the traction logic is bad...

i can't find the 330 and 346 in the error list from ZAPI manual...is that some inner data that only they know maybe?