The relay supply voltage must be 12.V.
The relay is activated when the key is switched on.
The glow lamp is on.
If the voltage is low, the VSM is defective.
Or the battery.
The machine does not have an ECU.
Check the CPS10 VSM pin 9 on the CPS55 connector located on the gearbox. Under the floors.
Cable marked 754.
Check the relay.
It is controlled by VSM.
Wiring diagrams are the same
B977 (H40-50-55-60-70FT), F001 (H30-35FT, H40FTS), G001 (H30-35FT, H40FTS), L177 (H40FT, H50FT, H60FT, H70FT), N177 (H40-70FT), N177 (H2.0-H3.5FT Europe) N177 (H2.0-H3.5FT Europe)
This is ONLY to be used to report flooding, spam, advertising and problematic (harassing, abusive or crude) posts.