I am checking for event code 108 and getting 37.8vdc on my meter as far as procedure that is to be done and don't find anything wrong with Access 3 CAN wiring @ CA401-1 and CA401-6 as it is mentioned to repair.
Went to code 300 for additional information as directed by manual and don't find anything wrong there following the manual. I swapped out access3 module with a donor with no help as it would go through lamp test then access1 goes blank. I swapped out Access1 as well with no help. Any ideas where to go from here.....
This is ONLY to be used to report flooding, spam, advertising and problematic (harassing, abusive or crude) posts.