Hello,
I picked up a used forklift for my shop. Serial number included below in my sig. I think it is a 1984. Mazda engine running on LP.

History is unknown but whoever had it was NOT a whiz with wiring. Many splices and shortcuts. I have a local shop that has been great with helping me order spare parts, but they can't/won't find a wiring diagram for me. I have a new alternator, coil, and voltage regulator. Most of the original wire harness for the regulator is intact and I have plugged in what I can, but there has been some splicing done and I have a few wires left that I want to be sure to terminate properly. Any pictures or schematics you can provide would help a ton.

Also, I went through the cooling system with rebuilt rad, new water pump, new hoses, and new overflow bottle. The old overflow bottle only had a hose going into the top of it from the fill neck of the rad. The bottom fitting on the bottle had no hose on it but it was clogged up with crud so the fluid never leaked out. Any pointers on where to run the overflow hoses to/from? I haven't found a "re-entry" point for the overflow into the cooling system. Was wondering if the bottom of the bottle should be fed from the top of the rad and then the top of the bottle just be sent to the ground?

Thanks so much!