Mazda VA and Ua engines - Maintenance & Troubleshooting discussion in Forkliftaction's forums

Discussion:
Mazda VA and Ua engines

Looking for information on how to remove push rod tubes from the head. I have to replace the o-rings at the bottom and can't figure out how to accomplish this. Please help.

Posted 26 Aug 2008 22:17
By jim_v
joined 26 Aug'08 - 61 messages
Michigan, United States

Post a Reply Report this post

Showing items 1 - 1 of 1 results.

Sort messages by:

We did that about 2 years ago. It's a little difficult but we removed the Distributor, Valve and side covers, and valve rods. We made a tool and pushed them from the bottom up threw the side cover opening. The engine was in an older Hyster S35XL I think. Hope this helps

Posted 27 Aug 2008 01:57
By Prentice
joined 25 Jun'08 - 600 messages
Ontario, Canada

Post a Reply Report this post

Post your Reply

Forkliftaction accepts no responsibility for forum content and requires forum participants to adhere to our rules of conduct. Click here for more information.

If you are having trouble using the Discussion Forums, please contact us for help.