1. Home
2. Forums
3. Technical Troubleshooting
4. Crown
5. SP3500

Crown SP3500:
ENCODER BEARING 32

HI, I'VE GOT A SP3510-30 MODEL THAT EVERY 6 MONTHS THE ENCODER BEARING 32 KEEPS GOING OUT. IT GIVES THE CODE 430 EVERY TIME. THIS IS A UNIT WITH VERY MINIMAL HOURS AND IS VERY WELL MAINTAINED. DOES ANYONE HAVE ANY IDEAS AS TO WHY THIS WOULD CONTINUE LIKE CLOCK WORK EVERY 6 MONTHS?

• Posted 14 Aug 2019 00:32
• Discussion started by OutlawDad
• Louisiana, United States

Thanks,

OutlawDad

Post a ReplyReport this post

A Crown Tech is the one doing the work.

• Posted 28 Jul 2020 02:34
• Reply by OutlawDad
• Louisiana, United States

Thanks,

OutlawDad

Post a Reply Report this post

Who is installing the bearing? Need to make sure it's not getting tapped in with a hammer. Even light taps make me nervous with those things.

• Posted 26 Jul 2020 03:35
• Reply by lumberjack
• Maryland, United States

Post a Reply Report this post

Check U,V,W connections at the motor are not short to chassis, also pump motor terminals to chassis. Any voltage between battery POS/NEG terminals and chassis?

• Posted 24 Jul 2020 19:09
• Reply by techno_nz
• Canterbury, New Zealand

Post a Reply Report this post

what would cause a voltage spike?

• Posted 18 Jul 2020 03:47
• Reply by OutlawDad
• Louisiana, United States

Thanks,

OutlawDad

Post a Reply Report this post

NOT SURE MAN. ALL I KNOW IS THAT THE CROWN TECHS CANNOT FIGURE IT OUT.

• Posted 14 Aug 2019 02:04
• Reply by OutlawDad
• Louisiana, United States

Thanks,

OutlawDad

Post a Reply Report this post

Maybe getting a voltage spike? Most sensors do not like over voltage.

• Posted 14 Aug 2019 02:00
• Reply by BREWSKI
• Nebraska, United States

BREWSKI

Post a Reply Report this post

Post your Reply

Forkliftaction.com accepts no responsibility for forum content and requires forum participants to adhere to the rules. Click here for more information.

Having trouble using the Discussion Forums? Contact us for help.