Crown SX3000 drive fault - Technical Troubleshooting discussion in Forkliftaction's forums

Crown WP 3000 SERIES:
Crown SX3000 drive fault

Hi All,

Have a Crown SX3000 that turns on line contractor comes in and drives fine.

But if you press the lift the line contractor drops out and truck won't drive but the hyd still work fine rekey and truck will drive as much as you like until you lift

Any help would be good

No fault codes

Posted 31 Aug 2023 03:37
Modified 31 Aug 2023 03:37 by poster
Discussion started by Jack_Coss
West Midlands, United Kingdom

Always happy to help

Post a Reply Report this post

Showing items 1 - 3 of 3 results.

Sort messages by:

Sounds about right. Might just be one battery that is dead sucking power from the others.

Posted 1 Sep 2023 02:23
Reply by DyslexicNerd_01
Wisconsin, United States

Post a Reply Report this post

Turns out to be bad battery's

Posted 1 Sep 2023 02:15
Reply by Jack_Coss
West Midlands, United Kingdom

Always happy to help

Post a Reply Report this post

With no error code it sound like there might be a bad fuse. If the truck were to close the contactor it would throw a code. Sometimes a fuse can blow up still allow low current to pass thru. Try removing that fusecand testing the resistance. Otherwise the tips on the contactor might be burnt.

Posted 31 Aug 2023 03:46
Modified 31 Aug 2023 03:47 by poster
Reply by DyslexicNerd_01
Wisconsin, United States

Post a Reply Report this post

Post your Reply

Forkliftaction.com accepts no responsibility for forum content and requires forum participants to adhere to the rules. Click here for more information.

Having trouble using the Discussion Forums? Contact us for help.