i did a good bit of research on this and found no answer.
this lift truck starts fine and runs for a good while then out of nowhere a check engine light pops up and then over heat and it hits limp mode.. if i kill it and start it back up it runs fine all over again.
things i tried/looked at the 6 pin connection by the bat. i jumped the first 2 pins and the check engine light flashed 1 time then paused and then flashed one time again.. so the code is 1
I'm told that means its lean or rich , idle high or low.
somebody please help me out with this...
Forkliftaction accepts no responsibility for forum content and requires forum participants to adhere to our rules of conduct. Click here for more information.
If you are having trouble using the Discussion Forums, please contact us for help.