Having a problem with an rr35tt
Reach locks up, won't go in or out.
Side shift and tilt work fine.
The over mast wire was damaged so it was repalced, still the same problem. Swaped the cards in the sequence control with some used cards still locks up. Coils check ok, voltage to the coils is a little low 19 to 21 volts. I ran a seperate negative and the reach works fine never locks. Voltage stays around 23 or 24 volts. Have good negative and positive to the sequence control, seems to drop after it exits. Has anyone run across anything like it???
Showing items 1 - 1 of 1 results.
Forkliftaction.com accepts no responsibility for forum content and requires forum participants to adhere to the rules. Click here for more information.