Showing items 1 - 3 of 3 results.
Hello , if the both sensors are calibrate correct without any fault you van not have the S257 and S258 error. Or the electrical control in steer unit are defective.
Be sure transmitter works oke with measurement in pathfinder , you can seen the voltage.
Thanks for answer. was calibrated, the steering motor unit and the drive wheel position sensor were changed, the truck is still not moving.
It could be a broken wire in the harness but I don't have an electrical diagram. could guide me
steering angle transmitter error, on steering drive unit,
Forkliftaction.com accepts no responsibility for forum content and requires forum participants to adhere to the rules. Click here for more information.