The lifts hydrualic pump is not working... - Technical Troubleshooting discussion in Forkliftaction's forums

Crown RC5530:
The lifts hydrualic pump is not working...

the forks are tilted all the way back and pump is bad. is there a way to tilt the forks forward to work on the pump/motor?

Posted 28 Nov 2020 13:59
Discussion started by werthy1
Ohio, United States

Post a Reply Report this post

Showing items 1 - 5 of 5 results.

Sort messages by:

Thanks again. took a couple of pig pads to soak up mess....

Posted 1 Dec 2020 15:19
Reply by werthy1
Ohio, United States

Post a Reply Report this post

Glad that worked. I can imagine the mess it made!

Posted 1 Dec 2020 10:21
Modified 1 Dec 2020 10:22 by poster
Reply by Triggs
California, United States

Post a Reply Report this post

I unhooked the two lines going to manifold and made a mess but use another lift to pull mast forward to get the room needed to remove motor/pump assembly.

Posted 1 Dec 2020 08:04
Reply by werthy1
Ohio, United States

Post a Reply Report this post

ok thanks. I will try that.

Posted 28 Nov 2020 15:04
Reply by werthy1
Ohio, United States

Post a Reply Report this post

You could loosen the tilt hose fittings and manually pull the mast forward

Posted 28 Nov 2020 14:21
Reply by Triggs
California, United States

Post a Reply Report this post

Post your Reply

Forkliftaction.com accepts no responsibility for forum content and requires forum participants to adhere to the rules. Click here for more information.

Having trouble using the Discussion Forums? Contact us for help.