Good morning sir,
Any body knows how to replace the steer/traction controller card,
no. 154-012-581/004. It this need to calibrate the board, Thanks
for the reply please help.
Thanks,
Rolly
Showing items 1 - 5 of 5 results.
Hello guys,
I buy curtis handheld 1313, but when i connect it on the truck
the handheld cannot get any information in the board even i try
to get the program to the other truck. I want to clarify if this handheld is suitable to this control board or not.
Please help , thanks,
Rolly
I try this Curtis model- 1309USB OEM only 4pin soi cannot
Fix to the 9pin plug, if their is adaptor to use this programmer
Is it possible to use.
Please advice,
Thanks,
Rolly
you can use the curtis handset to change traction parameters
the steering controller you can not
Good morning swoop23,
I try to fix the diagnostic 9 pin socket to the Curtis programmer
But their is no response to the programmer , I fix the programmer
To the traction controller with 4 pin socket and it is working. So can
I install the parameter in that module coz the steer/traction card have 9 pin socket in the left side of the module.
Please advise,
Thanks,
Rolly
when replacing the controller you can use the curtis handset and save profile, then load profile into new controller.
You will need to recalibrate the control handle after controller replacement.
Forkliftaction.com accepts no responsibility for forum content and requires forum participants to adhere to the rules. Click here for more information.