Code 845 after lift cylinder seal change. - Technical Troubleshooting discussion in Forkliftaction's forums

Crown RR5200S:
Code 845 after lift cylinder seal change.

Changed Left Lift cylinder seal...after lowering mast onto supporting block. started truck back up and codes out. tried manually tripping hydraulic contactor...will run pump but wont allow lift to raise.

Posted 21 Dec 2017 06:02
Discussion started by JMyers
Indiana, United States

Post a Reply Report this post

Showing items 1 - 1 of 1 results.

Sort messages by:

Once you mis-stage the mast, you have to go into service mode.. calibrate....C5 valves....lift minimum. Then raise forks off of blocks and chains. Turn off and re-key. Lower forks. Then go back in and erase codes. Don't forget to bleed out the air in the cylinders.

Posted 27 Dec 2017 13:48
Reply by Ifixit
Pennsylvania, United States

Post a Reply Report this post

Post your Reply

Forkliftaction.com accepts no responsibility for forum content and requires forum participants to adhere to the rules. Click here for more information.

Having trouble using the Discussion Forums? Contact us for help.