1. Home
2. Forums
3. Technical Troubleshooting
4. Hyster
5. J30XMT

Hyster J30XMT:
access code

J30XMT. K160N01889J. Trying to access display. 55555 not working. Is there a factory access code? Unit not operating. All I can get is the flashing wrench. Only numbers displayed are 12576.

• Posted 15 Feb 2017 13:14
• Discussion started by tonymfg
• New Jersey, United States

Post a ReplyReport this post

DTC 12576
Motor Voltage Not OK controller could be faulty this could be left or right controller
DTC 12576
DC Bus Charging
Timeout
carry out battery test on all cells and check under load if possiable and acid sg and also make sure water in battery
I am trying to put the whole diagnostic for both codes

• Posted 16 Feb 2017 22:43
• Modified 16 Feb 2017 23:07 by poster
• Reply by redbull
• Queensland, Australia

Post a Reply Report this post

Post your Reply

Forkliftaction.com accepts no responsibility for forum content and requires forum participants to adhere to the rules. Click here for more information.

Having trouble using the Discussion Forums? Contact us for help.