Hyster model W40Z, serial number B218N05812B. EP 108. Had a code AL10. Followed the limited troubleshooting I had for that code and replaced Zapi controller. Ran great for about 20 minutes then started throwing code AL14. Will do it when trying to traveling in high speed in either direction. Lift stops and will not move or go up or down. If your reset the handle, it goes to working again until high speed is called for. Any ideas? All battery cables are new and it had a full charge on it. One battery is new, the other three are a couple of years old. I also replaced the wires from the battery connector to the battery charger and the battery charger is about two weeks old.
Showing items 1 - 5 of 5 results.
I have a W30ZR with the industrial 24 battery and have codes AL06 and AL10 any help would be greatly appreciated.
Have an email address to post in your profile????
I have 55 ohms on one and 50 on the other(I have two controllers). Not having a wire schematics kills.
alarm 10 and alarm 14 are related depending on the software version in the controller, older versions would show the alarm 14
cause is fault in the main contactor
Main contactor coil shorted/open.
Check contactor coil for correct resistance of 45 to 55 ohms.
Forkliftaction.com accepts no responsibility for forum content and requires forum participants to adhere to the rules. Click here for more information.