Showing items 1 - 9 of 9 results.
Hi Kyle123, I have the same problema. If the plug is connected properly, then, where is the problem?? in the SAS board or CPU board.
WESHALE......you would be better off starting a new thread with your trucks full MODEL AND SERIAL NUMBER...
I'm having the same issues. No direction or tilt with a 62-2 and 67-1 code. Did you find the problem on your truck?
F0-2 is EHPS abnomality. Is the power steering motor running constantly?
I have the same codes right now and I found a burnt spot on the ST card which is located behind the hydraulic control levers. ***WARNING*** installed refurbished card and the next card burnt also.
can you tell me what code f0-2 is on a 7fbcu25? thanks.
thank you kyle. will check if this works. will reply accordingly.
code 62-2 shows to be a shorted tilt angle sensor. It will present as no forward tilt or no automatic fork leveling.
code 67-1 is a lift height switch abnormality. It will present the same symptoms as code 62-1 along with a low lifting height control.
code FE-4 is a communication system abnormality between the main controller and the SAS controller. This will present as having disabled tilt control.
Each of these codes references plug CN 141 in the troubleshooting guide. You could start by making sure that plug is still plugged in.
Forkliftaction.com accepts no responsibility for forum content and requires forum participants to adhere to the rules. Click here for more information.