1. Home
  2. Forums
  3. Technical Troubleshooting

Hyster H3.5FT:
code 978_3

i Can anyone give me some information about a fault code 879-3 it displays on the dash and then after the engine cuts out automatically it then shows the full code " SPN 879 FMI 3 "

Any Ideas about what sthe problem is would be greatfully recieved
  • Posted 7 Feb 2014 08:17
  • Discussion started by tarek_b
  • annaba, Algeria
Post a ReplyReport this post
Showing items 1 - 1 of 1 results.
DTC 879-3 - Left Turn Lamp Driver Output OORH

Check LH tail light assembly for damage or short in wiring harness.
  • Posted 17 Feb 2014 06:44
  • Reply by Mr. Twister
  • New Jersey, United States
Post a Reply Report this post

Post your Reply

Forkliftaction.com accepts no responsibility for forum content and requires forum participants to adhere to the rules. Click here for more information.

Having trouble using the Discussion Forums? Contact us for help.

Forklift Diaries
Last Week's Most Read
edition #1227 - 24 April 2025
Movers & Shakers
Linda Häkkilä Linda Häkkilä
Linda Häkkilä
vice president, Investor Relations, Konecranes
Rhiannon Stone
vice president operations, Elokon Group
Bennit Schmieder
President, EP Equipment Europe
Mathias Höglund
Senior vice president human resources, Kalmar
Global Industry News
edition #1228 - 1 May 2025
There is simply no ignoring the push for a greener, more sustainable materials handling equipment industry as manufacturers and customers alike seek eco-friendly solutions to reduce or eliminate carbon emissions... Continue reading

Showcased in the Virtual Expo

Movers & Shakers
Linda Häkkilä Linda Häkkilä
Linda Häkkilä
vice president, Investor Relations, Konecranes
Rhiannon Stone
vice president operations, Elokon Group
Bennit Schmieder
President, EP Equipment Europe
Mathias Höglund
Senior vice president human resources, Kalmar
Hangcha CBD15
Hangcha CBD15 2021
China
Used - Sale
USD1,600
UN Forklift FGL18T
UN Forklift FGL18T
HANGZHOU, Zhejiang, China
New - Sale
|
Forklift Diaries
From the forum discussions …
"Remove the coils and ohm out the pins. Coils take a different number than regular 4y plugs... If code is there then it is an ecu issue."
ron_k, United States
Read & Post in our Forums
Upcoming in the editorial calendar
ARTIFICAL INTELLIGENCE
May 2025
Ask us about editorial contribution