Hey I have Crown RR5200S that has a code 814 come up. I found the HGTRS switch on the carriage wasn't closing when in free lift stage so replaced it. Still the code comes back. Is their a calibration for the height encoders cause I can't seem to find where its at?
Showing items 1 - 6 of 6 results.
I did a comparison with another reach truck same model. The encoder is at 127 counts the whole time in free lift stage until it hits the second stage then it starts counting down.
II don't believe so, you could check the encoder wheel to make sure its tight on the mast
Is it suppose to count in free lift stage at all?
yeah, theres not another one. just the switch on the carriage
I checked the ECR2 in the Analyzer on A2.19. Well the encoder starts counting and gets not even 2 counts then stops until it reaches the second stage. Then it counts just fine afterwards. Where's this encoder even at on the mast cause I'm not seeing one on the carriage anywhere?
Might check your height encoder and make sure that it's counting
Forkliftaction accepts no responsibility for forum content and requires forum participants to adhere to our rules of conduct. Click here for more information.
If you are having trouble using the Discussion Forums, please contact us for help.