Hi. I have à prblme withe code T603, what is the solution can same one give us a answer please, thnx.
Fault 260 Lifting
Precondition:
The controller detects that the solenoid current in the circuits Aux 1/A and Aux 1/B is too high.
Effect on the truck:
AUX1 (supplementary function 1) disabled
Possible causes:
1. Valve (2Y5) defective.
2. Valve (2Y6) defective.
3. Connector (2X5) defective.
4. Connection between the valves (2Y5,2Y6) and the controller (N1:90,N1:82,N1:112) short-circuited or faulty.
Hi, did someone find The L-260 error code for an H35D Linde??
start whit good serial nummer
what steps should be taken,can i clean control valve?
260 PWM signal valve coil not correct: Lifting i take dis from 387 sery
Hi,can someone tell me how to sloved linde e25s error l260
Hi,can someone tell me how to sloved linde e25s error l260
Thnks
Thanks for help it will be working. I change the Valve&solenoids (2Y4)&(2Y3) THANKS again
Fault 255 Lifting
Precondition:
The controller detects that the solenoid current in the circuits Tilt Forward/Tilt Back is too low.
Effect on the truck:
Tilting function disabled
Possible causes:
1. Valve (2Y3) defective.
2. Valve (2Y4) defective.
3. Connector (2X5) defective.
4. Connection between the valves (2Y3, 2Y4) and the controller (N1:91,N1:92,N1:107) broken or faulty.
Hi can samone tell me what is code L254,L255
Hi can samone tell me what is code L254
pomp reverse current zero whith power stage activated
best regards