Hi Jerry
Can you send me the drawings you do have.
Thanks
Greg

Hi
I have a 1990 still r70-45 merc diesel forklift but no wiring diagrams can anyone help, as the truck will not move forward or back but does rev up as you step on the pedals
Thank you
Greg

Hi, I am also after a wiring diagram for a R70-16 with a VW engine and is powered by LPG.
The engine runs, the forks work but the truck will not drive. I have checked the fuse which is OK, when you hold the coil in it will then drive, so the fault is on this safety circuit which includes the handbrake switch, but I do not know what else is in this circuit, hence needing the wiring diagram.
Thanks.

hello every body,i am new in this forum too.i have still R70-40(old diesel),the engine is ok but when we want to move it the BUV20 (power transistors) of the power board become damage.I would like to have a electric drawing or service manual, every body would you help?thanks.

Hello every body, I am new in this forum,and I have STILL R70 25 (gas),the engine starts normally,forks are ok, but no drive.
Please can any boby send me any wiring diagram or drawing.
Thanks all.

Hi All, I have a STILL R70 diesel / electric hybrid with a 2.5T lift capacity. I am after the wiring diagrams if any body has them for the following reason......I suspected that the engine was on the way out and have been using easy start to fire up in the mornings......however, since discovered that I am not getting the glow plugs hot enough....as we appear not to be getting the full 24 volts and around the circuit.......put new plugs in, replaced some of the wing and suspect either the batteries not man enough (does anybody know what they should be in Amp / hour?)......

Hello out there,I am glad I found you guys,Just been ripped off by local so called specialist,I have got an 1988 Still R70 TFG16,same old thing,engine starts,arms move up and down but no drive,replaced a few bits but could do with workshop manual or wiring diagram better than that let me have your number and I will ring you,or if your not far away I will pay for travel and some bear money,thanks for your time.

hi laci done that regards dave.

hello, write you your email adress in ABOUT or SIGNATURE.
Best regards, Laci

hi alan my truck is a r70 diesel 1988 it has a fault it will not go into drive or reverse it has been stood for two years started it up everything works engine is a vw 1600 forks work all lights on the truck work just wont go into drive any ideas ,have you got the manuals for this truck if so can you send them to me regards dave. or does any body have any ideas regards dave

Hi Alan My truck is STILL R70-16 sn: 70314605

Please could you let me know the serial number of the truck. I could possibly supply the drawing.

Or if you could pay the rent i will come and have a look

I have found a manual the has 28 pages that talk only about the test points and functions on the u200 and e36 boards.
The individual pins on the connectors are discussed one by one in the trouble shooting section.
The earlier service manauls did not have this info, but the later manual written for a later truck, has to be used with a pinch of salt. Essentially the design has stayed the same but there were efforts to improve from one generation of truck to another

I have a STILL R70 16(1995), I had lost the manual long ago, now my truck got a problem of the driving, it can able to start and raise the arm, but did not move, I supposed some component has damaged, I would like to have a electric drawing or service manual, every body would you help?

sorry i didnt post my e mail,its [email address removed],also note that any cost or fees involved will be reinbursed. advise