steer encoder ecr2 - Technical Troubleshooting discussion in Forkliftaction's forums

Crown SP3500:
steer encoder ecr2

I AM GOING TO CHANGE STEER ENCODER FOR THE FIRST TIME ON A SP3500. THE HANDSET I USED ON THE OLDER MODELS DOESN'T PLUG IN CAN ANY ONE WALK ME THROUGH THE ECR2 ALIGNMENT PROCEDURE. I HAVE A SERVICE MANUEL BUT IT DOESN'T GIVE ME HOW TO CENTER ENCODER

Posted 5 Feb 2020 00:51
Discussion started by MRLIFTOFNY
New York, United States

EMAIL ; MRLIFTOFNY@AOL.COM

Post a Reply Report this post

Showing items 1 - 3 of 3 results.

Sort messages by:

Loosen the 2 screws and turn it

Posted 11 Feb 2020 08:19
Reply by Randy_Keilback
Pennsylvania, United States

Post a Reply Report this post

whats the trick to moving the encoder at the front of the lift and seeing the 0 at the dash do you need 2 people
thanks ray

Posted 11 Feb 2020 07:20
Reply by MRLIFTOFNY
New York, United States

EMAIL ; MRLIFTOFNY@AOL.COM

Post a Reply Report this post

Power up truck and wait until it times out. Lift drive unit enough to physically turn the drive unit and line up the 2 lines etched in the drive unit and bearing pivot. Find ECR2 counts through Access1. Physically turn the encoder to zero. Drop the truck and calibrate steering.

Posted 10 Feb 2020 14:37
Reply by Randy_Keilback
Pennsylvania, United States

Post a Reply Report this post

Post your Reply

Forkliftaction.com accepts no responsibility for forum content and requires forum participants to adhere to the rules. Click here for more information.

Having trouble using the Discussion Forums? Contact us for help.