Report this forum post

ok..this is a C801N01818Y. sent controller in for repairs. installed. unit powers up now.. but "slack chn" message appears. replaced encoder upper left side of mast. unit has lift but does not lower. also still no travel. "slack chn" message still appears. does anyone has a wiring schematic i can have. i'm begging to think there are some faulty wires inside the main cable. battery is at 90%.

ok..here is an update...unit powers on..shows ****, battery voltage, Ver 1.7, hours, then Slack Chn message on display. horn works. lift works. no travel and cannot lower. fwd/rev contactors do not close. connected 1311 handset to curtis 1243 traction controller and it works. i can see all the menus and settings etc on the Handset screen...accel POT ok...fwd input OK...rev input OK. i then connected 1311 handset to 1310-5201 master controller and shows "no communication error". this master controller was just repaired by FSIP.

p.s. i have a good used 1310-5301 controller and wanted to know if i can use the copy or clone feature on the handset to try to make it work. i don't know what else to try.

thanks,
jay
  • Posted 23 Feb 2014 06:25
  • Modified 23 Feb 2014 11:13 by poster
  • By glenn_levit7
  • joined 10 Jul'07 - 78 messages
  • Texas, United States
Montacargas, Tequila y Limon!

This is ONLY to be used to report flooding, spam, advertising and problematic (harassing, abusive or crude) posts.

Indicates mandatory field
Taylor XC300M
Morgantown, Pennsylvania, United States
New - Sale & Hire
Manitou M50-4
Braeside, Melbourne, Victoria, Australia
Hire
Upcoming industry events …
September 4, 2025 - Melbourne, Australia
September 17-18, 2025 - Miami, FL, United States
October 21-23, 2025 - Barcelona, Spain
Movers & Shakers
Jan Zuurbier Jan Zuurbier
Global CEO, Swisslog
Board member, UKMHA
Strategic advisor, Roboteon
CEO Americas, Hai Robotics