Does the code come up on the dash display or with the hand set tester? When using the hand set, always keep the setting control **** fully clockwise or you will get brush wear codes. They will also remain in fault code memory.
Do these ERC060's not have GE SX controlers?
Today I had a ERC050 with a code #41 which is drive circuit overheating but I'm not sure if it is the armature overheating or the controller overheating. Does anyone know if there is a thermistor in the drive motor? Mike?
This is ONLY to be used to report flooding, spam, advertising and problematic (harassing, abusive or crude) posts.