The right drive motor controller caught fire and melted. All the wiring and motor check out and the truck rolls freely doesnt seem to be any brake / drive unit binding. wanted to know if the right controller is the master or slave and what kind of programming would need to be done after controller replacement.
TVH has a controller but we dont know if it comes with the small printed cicuit board, has amyone seen this problem before and any suggestions, the customer ran the truck 3 shifts with an opportunity charge between 2nd and 3rd so we think it may just be high amps over usuage, fuse did not blow etc any help would be appreciated.
model # EFG-DFAC-20SPGE110-480DZ serial # 89.92.48.42
This is ONLY to be used to report flooding, spam, advertising and problematic (harassing, abusive or crude) posts.