Hi guys,

Ok so heres an update on the problem.

I'll go into the config menu,

DISABLE SMARTi,

confirm changes, Y.

QUIT config. Screen shows DONE. Here the truck should start.

But here I get stuck at the superword entry screen. If I enter the code, I just end up back in the config menu. If i quit the menu again, I just go in circles. The truck doesn't start/enter self test.

If I shut off the truck through key switch, and try to start it, same thing. It enters the superword entry prompt to get me into the menu, but doesn't perform a SELF TEST or attempt to start the truck.

It's only when I go back into the MENU, and ENABLE SMARTi, save changes, and restart the truck, am I able to get the truck to SELF TEST and start. At this point of course, I have error code 5D again.


So to sum it up.

- Not a SMARTi equipped truck.
- SMARTi disabled in the menu, SELF TEST won't run, truck won't start.
- SMARTI enabled in the menu, SELF TEST runs, truck starts but inoperable with error code 5D.



Any help?

Regards,