This one I know there is probably some answers that are not going to be typical......I'm just looking for a place to start here.

I am building an electric car. I have saved ALL of the electronic components from a old stand up forklift, and am in the process of installing them into a Geo Metro.

I have a GE 6.7" traction motor already bolted up to the transmission, and am ready to start the re-wiring process.

Now, I saved pictures of EVERY wire that was disconected, so I do know where everything goes......

what should my settings be for my EV100? The car will typically be driven in 1st. 2nd and 3rd gear, with an estimated top speed of 30MPH. Curb weight is 1900 - 2000LBS, but gearing is a bit taller than a conventional forklift. Should I be setting my time for the (don't remember what to call it.....) "Up to top speed" very short, or longer? My thoughts were to set it very short, and let the 1A take most of the abuse.........like I said, just my thoughts...

Here is my cards info....
EV100T1TT1
serial number - PR LX-047766