SN: A268N14208M
Could the encoder wiring cause this code, probably would give different code, From what I'm reading it's going to be the power cables or motor windings, short to frame or open's.
I had the HYD motor rebuilt. The original problem was it would lift very slow, creeping, then jump and jerk and code 8976.
Now it's working 99% of the time and all the sudden during lift code pops up, reset with key switch and it's working again. have checked all the power cables, could it be the controller?
I really would like some input on this and hear your experiences with this code. Thanks!
This is ONLY to be used to report flooding, spam, advertising and problematic (harassing, abusive or crude) posts.