1. Home
  2. Forums
  3. Report post

Report this forum post

I have a RM6095S-45 that reaches out normally but stops about 2 inches from retracting all the way back in. It will reach and retract normally when calibrating but as soon as calibration is saved and the truck is powered off then on, it repeats the same issue. i have replaced the reach sensor, swapped out Access 7 and Access 4, reloaded software and even replaced accessory pump (recommended by Crown). nothing has worked. Am i missing something? Thanks in advance
  • Posted 14 Jan 2020 08:12
  • By NJ2ATL44
  • joined 14 Jan'20 - 2 messages
  • Georgia, United States
PCW III

This is ONLY to be used to report flooding, spam, advertising and problematic (harassing, abusive or crude) posts.

Indicates mandatory field
Fact of the week
According to studies published in the English Journal of Medicine, the impact of daylight savings is revealed by a 24% increase in heart attacks on the Monday following the spring shift forward. When clocks move back in autumn, heart attacks drop by about 21%, suggesting that loss of sleep is an important driver.

Showcased in the Virtual Expo

Fact of the week
According to studies published in the English Journal of Medicine, the impact of daylight savings is revealed by a 24% increase in heart attacks on the Monday following the spring shift forward. When clocks move back in autumn, heart attacks drop by about 21%, suggesting that loss of sleep is an important driver.
Your Focus
Stuart Taylor
How positive friction prevents forklift accidents before they happen
Stuart Taylor
Read blog
Read more Your Focus blog articles
Last Week's Most Read
edition #1257 - 20 November 2025
Fact of the week
According to studies published in the English Journal of Medicine, the impact of daylight savings is revealed by a 24% increase in heart attacks on the Monday following the spring shift forward. When clocks move back in autumn, heart attacks drop by about 21%, suggesting that loss of sleep is an important driver.