Hello Everyone,
So the code is for a short to batt positive for the E-Hyd Enable according to the book. The troubleshooting steps say to check the terminals at the relay and replace as necessary.
The thing is I can't locate the relay. The book even has a page that says where it is and it is not in that location. Any help on what the issue may be or the location of the relay are greatly appreciated, thank you.
Hyster J50XN electric 4K Forklift
Showing items 1 - 3 of 3 results.
Nate,
The relay should be located on the right side of the dash behind the plastic cover. The other location is for three wheel lifts, relay is located under the floor plate on the left side at the fuse box. Need to make sure all connections are good from relay to VSM. Good Luck.
Hi , did you figure out the code 9004, thank you
Hi, I have the same problem - error 9004. I replaced the relay. it didn't help. Have you made progress with it?
Forkliftaction accepts no responsibility for forum content and requires forum participants to adhere to our rules of conduct. Click here for more information.
If you are having trouble using the Discussion Forums, please contact us for help.