Drive system - Maintenance & Troubleshooting discussion in Forkliftaction's forums

Discussion:
Drive system

Esc030ABN24SE083 ser#N452247. This unit runs with a super pc8 drive system. It will not creep in reverse. It will go full speed in reverse after holding the throttle wide open for about 4 seconds. Forward works normally. The battery is fully charged.

Posted 15 Feb 2025 09:53
By Spielman
joined 15 Feb'25 - 1 message
Oregon, United States

Kendall Spielman

Post a Reply Report this post

Showing items 1 - 1 of 1 results.

Sort messages by:

Spielman,

Make sure the control handle switches are adjusted correctly for reverse travel. Check are connections at the reverse contactor are clean and tight. Make sure all cables are tight. Check drive motor brushes. Good Luck.

Posted 18 Feb 2025 00:48
By Fishmech
joined 12 Jul'17 - 370 messages
Virginia, United States

The hard to do we do right away. The impossible just takes a little longer.

Post a Reply Report this post

Post your Reply

Forkliftaction accepts no responsibility for forum content and requires forum participants to adhere to our rules of conduct. Click here for more information.

If you are having trouble using the Discussion Forums, please contact us for help.